Gasoline Huter Trimmer Starts And Stalls
In general, such a conversation should start with the fact that after buying a garden gasoline tool it would be better to first familiarize yourself with the instructions attached to it. Then many problems could have been avoided. But since this happened the gas trimmer does not start, then we must look for sources of inoperability. And in this article we will consider the main reasons why the trimmer does not start on the example of the Elitech T750 model, as well as tell general recommendations for the operation of such a tool.
Start with the banal! We will figure out how to properly start a gas trimmer. It may be that the reason lies precisely here.
First you need to bring the red toggle switch on the trimmer bar to position "I". This means turning on the power.
Then you need to switch the fuel supply lever on the carburetor and use the fuel “suction” button (similar to a pipette, located on the carburetor). This is necessary to supply gasoline to the engine. Return the fuel supply lever to its original position. Finally, sharply pull the starter handle toward you. The trimmer should work. Try several times if the first time fails. If after such manipulations the situation has not changed and the gas trimmer does not start, then you should first examine it yourself before leading to the service center. There are two main reasons why a garden trimmer will not start:
Video: Gasoline Huter Trimmer Starts And Stalls
- Violation of the power circuit.
- There is no fuel.
- Let’s start with the ignition problems. In most cases, it is caused by the need to change the spark plug in the engine. It is done like this:
- First of all, we must take care of security measures, make sure that the trimmer is turned off. We bring the above toggle switch to the "STOP" position.
- Then remove the rubber protection from the plug and the wiring terminal. Using a special candle key, we unscrew the spark plug and replace it.
- After that, we assemble the device and carry out the procedure for trimming the trimmer described above.
The second reason the garden tool doesn’t work is because the fuel has run out. On the Elinech T750, the fuel tank is located near the motor, but on most trimmers it is there. We unscrew the cap from the tank and fill it with gasoline (the most optimal option is the AI-92, it is inexpensive and does not clog the carburetor like the AI-76). Do not forget to add special engine oil to the tank, 50 grams per gas tank is enough, without it the motor will begin to “sneeze” and will quickly become worthless. After we close the tank with a cap, wipe the surface of the trimmer and our hands with a dry cloth. We also do the above manipulations to turn on the garden tool.
If the gas trimmer does not start as before, then it makes sense to return it for repair. And the reason for this decision is simple. if you do not have the appropriate skills, repairing the equipment is almost impossible.
In order for the tool to serve as long as possible and there are no such malfunctions, you should, first of all, familiarize yourself with the instruction manual for the trimmer. Pay special attention to the operating time of the engine at the trimmer. take a short break every 15 minutes of operation and, finally, properly care for the tool, wipe it after work, lubricate it with graphite grease. Observing such simple rules, you can significantly increase the life of the tool and it is quite possible that you do not have to look for reasons why the gas trimmer will not start.
35,913 total views, 2 views today