How to Change Magneto to Husqvarna 128r Trimmer

September 17, 2020

the buyer can return the gas trimmer if he discovers from him:

  1. a flaw that complicates the process of its operation personally for the buyer (article 18 of the Law on Consumer Protection);
  2. a significant technical flaw (non-working button, non-functioning mode, etc.);
  3. a slight visual defect (scratches, dents, chipped paint elements);

If one of the above grounds for a return is found, the buyer can return the device back to the seller, demanding in return:

Lawn mowing does not start: causes and remedies

Breakdowns, closures, jammed button. all this leads to loss of spark. If this did not work, then you need to look at the sparking system itself.

If the ignition system is easy to diagnose and rarely fails, then there are often problems with the power system of the lawn mowers.

Because of it, the engine does not start most often.

Before climbing into a carburetor, which, despite its simplicity, can be irrevocably corrupted by a curvature arm, you should start with a more detailed launch diagnosis.

Causes of breakdowns of gasoline and electric trimmers

Everything must be done according to the manual attached to the device, since when the piston group fails, its replacement will cost about 70% of the total cost of the trimmer. Refuel with the expectation that you will completely use it up when doing work.

The gasoline remaining in the tank after a while loses its properties and can harm the engine.

Therefore, do not prepare the mixture for future use and in large quantities.

If the lawn mowing does not start well, try to drain the “old” fuel from the tank, and fill it with a freshly prepared mixture.

Lawn mowing back within 14 days of purchase

The seller has the right to conduct an examination, you have the right to attend it, to challenge its results.

If the requirement is not satisfied, then you have the right to apply to the court, on the basis of Art. 17 of the Law. With respect, Nadezhda. June 21, 2015, 18:56 Was the lawyer’s answer helpful?

1. 0 Collapse Customer Clarification Good afternoon. Today I handed the seller a written complaint.

First start-up and running-in lawn mowers

From the instructions you will also learn the recommended type of fuel, as well as the recommended type of engine oil. Prepare fuel in small quantities sufficient for one mowing of grass.

Use special plastic canisters for fuel, or separate glass or metal utensils. Oil is best filled with a medical syringe.

Going to run in a new lawn mowers, many are faced with the problem of preparing the fuel mixture.

Video: How to Change Magneto to Husqvarna 128r Trimmer


And the reason for this is disagreement in the instructions of the manufacturer of the tool and in the instructions of the manufacturer of motor oils. The former recommend a proportion of 1:25.

The second recommend 1:50. Who to believe? How to proceed? According to experts, if manufacturers write the proportion 1:25 or 1:30 in the instructions for the lawn mowing, then most likely this is either a cheap tool with poor cooling, or the manufacturer does not know which oil the consumer will add.

But here it must be understood that an excess of lubricant does not in the best way affect the performance of the trimmer.

Doesn’t Start a New Trimmer Petrol Causes

Trimmer Patriot PT-545.

lawn mowing Patriot 545. patriot rt 545 Looked. comment!

Now mowing grass with a trimmer is not just a problem, but in a sense, even a game. Electric trimmer MTD ET 1000 CB 1. After 3 years of operation. Scythe trimmer electric stig.

Overview: Overview of the electronic trimmer MTD ET 1000 CB 1 from a real user.

Is the seller required to start a gas trimmer

You can find out the proportions from the instructions that came with the tool or on the lubricant label.

From the instructions you will also learn the recommended type of fuel, as well as the recommended type of engine oil. Prepare fuel in small quantities sufficient for one mowing of grass.

Use special plastic canisters for fuel, or separate glass or metal utensils. Oil is best filled with a medical syringe.

Going to run in a new lawn mowers, many are faced with the problem of preparing the fuel mixture.

This will ensure proper performance of the 2-stroke trimmer motor. Pre-prepared fuel eliminates the hassle and mistakes when mixing the fuel immediately before mowing. It is necessary to mix the fuel so much that it can be used for a month, not longer, because when stored for more than 1 month, the oil precipitates and the fuel ages.

Why the lawn mowing does not start. we troubleshoot

Here, for repair, an ordinary candle key (probably every motorist has one) and a spare candle will do.

  1. We set a gap with a distance of 1 mm (you can check with any coin);
  2. We return everything to its place and try to start a trimmer.
  3. Dry it thoroughly (do not calcine);
  4. The excess fuel in the chamber is drained through the spark plug hole and dried;
  5. We twist the candle and wipe it;
  6. We clear an old candle from a deposit by means of a file or a lady’s file;

Dry the canal for at least 30-40 minutes. Otherwise, there is a risk of re-pouring a new candle.

If the candle is working, the nest where it is completely dry and the lawn mower does not want to start, we lubricate the threaded connection with gasoline. It should be slightly moistened.

No matter what wonderful spark a candle gives out, there is simply nothing to light up in a dry chamber. If the engine

The first launch and running the lawn mowers. secrets and subtleties

You can find out the proportions from the instructions that came with the tool or on the lubricant label. From the instructions you will also learn the recommended type of fuel, as well as the recommended type of engine oil.

Prepare fuel in small quantities sufficient for one mowing of grass. Use special plastic canisters for fuel, or separate glass or metal utensils.

Oil is best filled with a medical syringe. Going to run in a new lawn mowers, many are faced with the problem of preparing the fuel mixture. And the reason for this is disagreement in the instructions of the manufacturer of the tool and in the instructions of the manufacturer of motor oils.

The former recommend a proportion of 1:25. The second recommend 1:50. Who to believe?