How to Cut a Hole In a Tile Angle Grinder

Content:

How to Cut a Hole In a Tile Angle Grinder

Cut a hole in a ceramic tile

Fig. 1 Finished Holes Carved Angle Grinder

The method in question can be used not only to form round holes, but also any other shapes. As for their size, the larger the better. Although the angle grinder can also handle small holes.

We will make a hole for the 40 mm pipe. In this case, the task is complicated by the fact that the hole must be made in close proximity to the edge of the tile. chipping is possible.

Step number 1. remove the dimensions and put the markings on the tile

We attach the tile to the pipe, while taking into account the thickness of the tile joints. We also measure the diameter of the pipe.

Fig. 2 Take sizes

Using a square and a vernier caliper, we mark the front of the tile. A caliper can be used as a compass.

Fig. 3 Marking on the front side of the tile

We turn the tile over and make symmetrical marking on the back side.

Fig. 4 Marking on the back of the tile

Step # 2. forming a hole in the tile

The essence of the method is to make multiple cuts inside the outline of the marked markings on the front side of the tile. Then turn the tile over and do the same, but only perpendicular to the cuts on the front side.

So, we make cuts, as shown in Fig. 5. We try not to go beyond the outline of the applied marking.

Видео: How to Cut a Hole In a Tile Angle Grinder


Fig. 5 Cuts in the outline of the marking on the front side of the tile

Turn the tile over. Repeat the same operation, only on this side. The tile can be put on two bars so that the hole is between them. Then the resulting debris will not interfere with the work.

Fig. 6 Cross cuts in the contour on the back of the tile

Step number 3. processing the edges of the hole

Now you need to make the hole more accurate. For this, we also use an angle grinder. It is more convenient to grind the edges, holding the angle grinder at an acute angle, while slowly rotating the tile.

Fig. 7 Stitching the excess without leaving the markup

Turn the tile over on the other side and repeat the operation to grind the edges. We control so as not to go beyond the markup loop.

Fig. 8 Back processing

Step 4. Finishing the hole

After processing, the angle grinder inside the hole remains technological edges. They need to be deleted. We do this with pliers and clean it with a round file.

Fig. 9 Finishing with pliers and a round file

OTC. work verification

The hole is ready and, despite the fact that it is in close proximity to the edge of the tile, no chipping occurred. The geometry is correct, the dimensions are met. The pipe end-to-end goes into the hole. a good job.

Fig. 10 Everything is accurate. the work is done

VIDEO: How to cut a hole in a tile angle grinder

How to cut a hole in a ceramic tile if there is no special crown at hand?

How to cut a hole in a tile angle grinder

Feedback from our readers is very important to us. Leave your rating in the comments with the reasoning of your choice. Your opinion will be useful to other users.