How to Cut Pvc Panels At Home

How to Cut Pvc Panels At Home

When sheathing a PVC surface, it is necessary to determine in advance and decide how to cut plastic panels. Currently, as a finish for a bathroom or BAL-KO, this material is almost out of competition and is very, very popular.

Someone can object and recall at least tile, as one of the most traditional finishing materials for bathrooms. Yes, tile is a classic and a tradition. But PVCs are easier and faster to install, much less maintenance is required, since they do not collect soap and precipitation from the water, in case of damage they are easily replaced. In a word, the tile nevertheless gives way to the first positions to plastic panels. And if you need to quickly and efficiently sheathe services, now many choose panels.

First of all, they fell in love with the people for the availability of self-installation. It causes the only difficulty: the standard length of the plank of 3 meters for most apartments is too long. In addition, the height of the ceilings can vary. both due to the errors of the builders, and because of the flight of the designer’s thoughts. So the finishing material needs to be shortened, which means. trimmed.

How to cut plastic panels, invented for a long time. And these methods. both popular and modern technological. are diverse enough to choose: either the one that seems more convenient, or the one for which there is a suitable tool on the shelf. Let’s take a closer look at several of the most popular methods by which this process is carried out. And consider in more detail each of them.

Video: How to Cut Pvc Panels At Home


Significantly speed up the process and give a fairly even cut. Almost indispensable for longitudinal separation. Like a hacksaw, they can process a stack of panels. if only its height does not exceed the length of the working surface of the tool.

There is one “but”: At high speeds, the panel begins to melt, due to which the edge turns wavy, and unpleasantly smelling and toxic substances are released into the air. So the work is carried out exclusively at low speeds.

In addition, it is necessary to accurately dose the efforts, since all three tools are quite heavy and, so to speak, aggressive. Too active use of them leads to damage to the panels. Given these shortcomings, many craftsmen recommend using a conventional, not electric, jigsaw for cutting. It separates the panels a little faster than the hacksaw, the cut is obtained without creases, convenient in longitudinal cutting and safe to use.

When using any tool, you need to fulfill some requirements. over, it is in your own interests if you seek to do without industrial injuries and unnecessary marriage.

Before cutting the panels, brought from the cold, they must be warmed up. The main mistake of inexperienced finishers: store the lining on BAL-KOne and enter as necessary, immediately starting to cut. PVC in the cold becomes brittle, and the cut is fragmented. Frequent and cracking almost along the entire length of the panel. So after entering the room the planks are left to mature at least night.

Cutting (again, in any way you like) can only be the wrong side down. If you place the panel incorrectly, its profile will collapse and cause installation difficulties. The panels of some manufacturers may have more significant violations: microcracks on the front surface, which also appear not immediately.

If you are cutting a stack of panels that should be the same length, stack them on 2 supports so that they do not sag or move. It is advisable to push the end that is not trimmed into something, at least against the wall. Otherwise, under the influence of the tool, the elements will move and turn out to be of different sizes.

And further: when cutting, it is advisable to use safety glasses. Especially when operating a power tool: the likelihood of a fragment flying off into the face zone is quite high. And if scratches on the hands are experienced by people indifferently, then eye injury is much more dangerous. Naturally, the finisher himself has to choose how to cut plastic panels. However, before you prefer one tool to everyone else, you need to know what difficulties you may encounter when using it. We tried to cover them in full.