STIHL mc 180 saw won’t start

Malfunctions in the ignition module

stihl, start

The gap between the ignition coil and the chain saw flywheel

It is not possible to look inside the ignition block. And the reason for this is the non-disassembled construction. Have it checked in a service center with a special tool to see if it’s working properly. It will be possible to solve the problem at home, if you make a replacement unit.

But before you run to the store for a new ignition unit for STIHL chain saws, you must make sure that the problem does not lie in the wrong gap between the contacts of the flywheel and the ignition module. The cause of the lack of spark can be either too much gap, or its complete absence. In the latter case, the flywheel will begin to contact with the contacts of the module, resulting in scratches on it.

STIHL MS 180 chain saw service centers use a special tool to adjust the clearance. If you don’t want to go to the service center in the near future and you need the saw urgently, you can also check it with improvised materials.

To do this you need to do the following:

chain saw starter motor

  • remove the starter;
  • Loosen the screws that secure the ignition module;
  • put a plate cut out of an ordinary plastic bottle between the module and the flywheel;
  • tighten the screws.

If all of the above steps give you a spark, the STIHL chain saw is ready to go. Otherwise you will have to reinspect. If the inspection again reveals a lack of clearance, you will have to look for the cause in the crankshaft bearings.

In a nutshell

This model is the pride of the German manufacturer and is a direct tool designed for light-duty applications. It can be used no more than twenty hours a month. This superb appliance is an easy way to tend your garden, make firewood for the winter season (see Information on “Gardening” in this owner’s manual) and build new trees and shrubs. how to cut down a tree ), produce cleared areas, and will also be an indispensable assistant in other areas of, shall we say, uncomplicated manipulation.

We can say that these mini-model chainsaws. because it has a low weight of 3.9 kg. It does not have a large oil tank and fuel tank. The manufacturer has equipped this device with a two-stroke engine quite enough power for light work.

over it is very quiet because during operation the noise level is not more than 98dB. So to give you a better understanding of the volume itself, just compare its noise to spoken speech, which has a reading of 76 dB.

The power output of this model is 2.6 W. It is worth noting that this is quite a significant level of power, given that it is not a professional chainsaw. The oil tank has a capacity of only 0.145 liters, and the fuel cell is 0.25 liters. The bar has a size of 350 mm, and the pitch is 0.325 inches.

Why the STIHL chain saw does not start after replacing the piston

In case the saw does not start after replacing the piston, it is necessary to check the fuel supply to the chamber, as well as to diagnose the ignition system. Very often when installing the control lever on a chainsaw, craftsmen forget to connect the wires coming from the ignition coil, as a result of which the spark is lost and the saw does not start.

Also, the problem could be a kink in the fuel line or if there is no fuel line at all. The causes of course there may be many, but remember that if all the work on replacing the piston carried out correctly, the tool should run without any problems and normally work.

STIHL-180 chain saw does not start: Key Reasons

Change the carburetor to the newest mix and it will work ! If you have any symptoms of hot starting/severe difficulty, you may also have a problem with a clamped piston.to change the oil seals on the shaft. And add the idle speed, it’s not hard.I do not know what model, most likely a hobby, there are only two bolts, one pushes the lever.You’re gonna have to tighten it up

From my experience, buy a new carburetor.

Grigory if the idle is normal and stalls, change the oil seals

The STIHL 180 chain saw does not start? The reason and the solution!

Today the manufacturer STIHL occupies a leading place among other companies that produce equipment designed for agricultural and construction work. The products of this manufacturer are not only famous for their high quality level, but also for their optimal price policy and the power of their models. It’s one of the world’s best-known brands.

It is probably hard to find anyone who does not own a STIHL chainsaw. But the fact that out of ten possible, six people definitely have them. No wonder, because STIHL chainsaws combine power with graceful design. But unfortunately, even such giants of equipment sometimes break down and need some kind of repair. Today we will focus on one of the moths of this manufacturer, namely the STIHL 180 chainsaw. Read about the STIHL ms 660 chainsaw here. So, let’s proceed.

STIHL 180 Spark Plugging Cause

To the record

I had the same problem, a brand-new saw after the 2nd refueling did not start, what I did not find in the tips, unscrew the plug, look at the piston, but do not do it if you feel that certainly compression, starter cord is pulled with effort. What remains for our customer to do is simple as hell, he filled the spark plug and because of his inexperience. Drain all the gasoline from the barrel. Unscrew the spark plug, check the spark plug, after the need to drain the gasoline from the cylinder, for this purpose turn the cylinder downwards gently pull the starter rope draining excessive gasoline approximately 10 times. Then I put the saw in the same position for 5 min to air out and dry it out, screw in the spark plug. fill up the tank with petrol and oil in the marked proportions. I put the lever in the cool start pulling twice smoothly 3rd jerk, started from the third jerk. And was about to take to the service. Same problem, the saw is new, on the 2nd refueling, did not start. Checked the carburetor overflow, the spark plug in the gasoline, after drying the spark appeared. After purging the cylinder, as described in the manual, tried to start. When the slide is “cold start” a flash, I moved the slide to the start position. does not start. Unscrewed the plug. again in gasoline. I blew out the starter a hundred times, the discrepancy is the same. And here comes your website, after reading Oleg’s advice (regarding blowing starter in the upside down position of the saw) tried, from the cylinder and carburetor poured over 10 grams of gasoline. Then I attached the spark plug (without screwing it in) to the end piece, set the choke to the start position, blew it off again. Reassembled, refueled. it started. So, thanks to Oleg for the good advice!

Why does the spark plug fill up in the chainsaw?

A short video guide on how to replace the membranes in the carburetor of a chain saw.

Oleg, thank you very much our client is excellent simply! In a nutshell my saw is 6 years old, I use it 10 times a year. I used to have a bad start and at some point that was it I took your advice. The problem is dared, sorry for the money for the newest candle and the air. Filter, but I think in the future may need. Additional thanks to. Dear Readers. Always start simple in most cases the problem is small. Good luck with your repairs!

Thanks to Oleg for the practical advice. You should write advice like that in the owner’s manual. New saw didn’t start on the 3rd time, there is a spark, but the spark plug gets. Made our customer remains because Oleg wrote, started with the first jerk.

Many thanks to Oleg. I was about to give the saw to service, but following Oleg’s advice, the answer was simple.

Took Oleg’s advice, started up without a hitch. All very simple but very effective. Thank you very much Oleg!

READ STIHL chain Saw Stops on Gas

Oleg, thank you very much. Did it to our client remains as you recommended in the Комментарии и мнения владельцев and my MS-180 started from the first start.

I have read a lot of information in the internet, read what Oleg wrote, decided to try, did to our customer remains in the same sequence and oh Magic. My old lady is lively (5 years) STIHL

180, although already did not pin my hopes to be honest, that I just did not for these 4 days, wanted to give in the repair, I thought died my “old girl, but no will serve more, it turns out so very simple, thanks Oleg great.

Ignition system

Very often the saw doesn’t start. Could be caused by a breakdown in the ignition. For diagnostics and elimination of causes necessary: remove the protective cap, remove the air filter (it closes access to further action) and the tip of the spark plug. We unscrew with a special wrench (usually comes with the saw) the candle and check it.

It is necessary to clean the electrodes from possible fouling. You need to pay more attention to the electrodes, clean not only the work surface, but also inside the skirt of the plug. You also need to check and adjust the gap between the electrodes. After that check for spark plugs. It may be necessary to replace the spark plug or the ignition lead with a spark plug lug.

If there is an oily residue on the spark plug, there is an excessive amount of fuel entering the cylinder. Adjust the carburetor. After all these manipulations it is possible to start the saw and check its functionality.

To summarize.

Actually, as you can see there are a lot of reasons why a STIHL 180 chain saw breaks down, but at the same time there are many solutions to the problem. If you are faced with this situation, then simply follow all the above written recommendations and then, for sure, you will be able to repair your device, and it will please you with its work for many years to come.

Don’t start with a chainsaw 180? Causes and Solutions!

Getting the Stihl MS180 chainsaw up and running

Today the STIHL chainsaw manufacturer is the undisputed market leader in the agricultural and construction industry. The products of this manufacturer are known not only for their high level of quality, but also for the optimal price and power of its models. It is one of the world’s most famous companies.

It’s probably hard to meet anyone who doesn’t own a Calmstress chainsaw. But that’s probably six out of ten people who have one. And no wonder, since the Calmstress chainsaws represent strength along with graceful design. But unfortunately these giants of technology sometimes fail and need some kind of repair. Today we will pay attention to one of the moles of this manufacturer, namely the STIHL ms 180 chainsaw. Read about the STIHL chain saw ms 660 here. So, let’s begin.

STIHL STIHL 180 chain saw carburetor malfunctions. Why the STIHL 180 carburetor overflows and shows some typical problems

After we have considered the structure of the carburetor to determine the reason why the fuel enters the combustion chamber in a larger volume is not difficult. This is caused by wear of the gasket between the compensator cap and carburettor housing. You will ask how this can affect?

The answer is simple. by shrinking, the gasket lets the diaphragm on top of it down by fractions of a millimeter. It, in turn, presses harder on the yoke of the needle valve. It opens more than normal and the fuel becomes overdrawn (overflows).

Another reason is the stretching of the diaphragm itself, this occurs as a result of natural wear and tear. It is impossible to prevent this process, but you can solve the problem by periodically changing all the gaskets, carburetor diaphragms, and the fuel pump. This is what the repair kit is for.

Chainsaw STIHL 250 starts and stops Reasons why the chainsaw starts and stops The chainsaw has long been a necessary tool for those people who have a summer cottage or home ownership. However, just like any other technique, this tool tends to fail, in spite of the uncomplicated device. The systemization of the main defects of the content STIHL chain saw does not start badly Causes What to do if the chainsaw does not start Good day, dear readers and subscribers of my blog! At one inopportune moment you might find your chain saw won’t start. But do not rush to immediately surrender the tool for repair, you can without problems and yourself to fix this failure. I’ll show you what to do when the chain block won’t start Electric STIHL Electric Chainsaw Videos Electric Saw MSE 170 CQ, MSE 190 CQ, MSE 190 C-BQ, MSE 210 C-BQ, MSE 230 C-BQ, MSE 250 C-QPromo-msk.the MSE 170 CQ, MSE 190 CQ, MSE 190 C-BQ, MSE 210 C-BQ, MSE 230 C-BQ, MSE 250. STIHL MSE 141C electric chainsaw Overview.AND WHY ARE THERE SO FEW Комментарии и мнения владельцев ON MY OCCASIONAL RESERVATION ABOUT THE 40 LENGTH TIRE

STIHL MS 180 chainsaw. technical specifications

The STIHL MS 180 chain saw stands out with its solid technical parameters. They include:

  • power. 2 l. с.;
  • The fuel tank capacity is 270 ml;
  • Oil refill tank capacity of 260 ml;
  • The possible length of the guide bar to be used is 30-35 cm;
  • 3/8″ chain pitch
  • assembled weight. 4 kg.

Modest fuel consumption is one of the main advantages of this model. The motor consumes no more than 2.9 l/mach when working under maximum loads. hour.