Reviews of popular garden equipment ~ lawnmowers, trimmers, brushcutters, brushcutters ~ on ARKHENO.COM Tips and solutions to possible problems in operation
What to do if a chainsaw is not started: tips, causes of malfunction and recommendations to eliminate the problem The design of this tool is based on a two.factor carburetor engine. Its power can vary greatly-it all depends on what the saw is for: if for home work, then it will be approximately 4 kW, but if for the roll […]
Read more
Why does it stall when idling? The first and most common cause of this malfunction is improper carburetor adjustment. To adjust the throttle, you have the STIHL adjustment screwdriver that comes with the machine. The regulating hole is on the right side of the STIHL 180 on the handle and is marked with “-” and “”. If a STIHL chain […]
Read more
Chainsaw malfunctions Chainsaws are units that are simple in design and operation. When handled correctly, malfunctions rarely occur and, often, they are quickly rectified by the owner himself. VQ35DE Engine Low Idle Stalling Issue G35 / 350Z Throttle Body MAF RELEARN PROCEDURE Our review is intended to help in extreme situations when it is necessary to understand and eliminate the […]
Read more
Trambler and moisture problems If your car stalls when you press the gas, but only with an unheated engine and usually in the morning, moisture may have accumulated under the distributor cover. Because of this, a breakdown occurs and as a result of a violation in the distribution of a spark. It is very simple to define it. Firstly, the […]
Read more
Why does the chainsaw start and immediately stall The chainsaw starts up and immediately stalls, the reason for this behavior may be hidden in the carburetor. A malfunctioning fuel pump or malfunctioning of the main fuel jet can cause this saw to behave like this. The inability to operate the chainsaw after starting, requires a full diagnosis at the service […]
Read more
Fuel supply system If fuel does not flow into the tank of the chainsaw, then there may be two reasons for this: Clogged filter. Lid clogged. In this case, the fuel is not supplied in full, and the tool does not start or starts and immediately stalls. The repair consists in cleaning the air filter and cover. The filter must […]
Read more
Why Tiller Shoots the Silencer? Often, in the event of malfunctions of the motor system, the tiller not only does not develop revs, but also emits obvious cutting sounds coming from the muffler. After that, it smokes and stalls, which causes obvious concerns for users. This problem can be caused by: excessive intake of oil in gasoline or diesel, due […]
Read more
The chainsaw starts and stalls. Why? There are several simple rules for the operation and maintenance of a chainsaw, the observance of which will allow you to maximize its service life. Preparing the correct fuel mixture, regularly cleaning filters and periodically replacing parts will save you from having to repair your tool for a long time. If it was not […]
Read more
Algorithm for checking the crankcase for leaks Remove the side cover and tire from the chainsaw. Unscrew the spark plug and put a lace with knots into the cylinder through the spark plug hole, thereby stopping the movement of the piston and crankshaft. As a lace with knots, you can use the old cord from the starter, tying knots on […]
Read more
Tiller starts up and stalls: causes of malfunction and mechanisms for their elimination From a situation when the tiller starts up, but immediately stalls at idle, the owners of either completely new or used cultivators are not insured. It can be caused by a number of factors: Problems in the ignition system: Leakage or breakage of electrical contacts; Spark plug […]
Read more