Trimmer Stalls When Shutter Is Closed

The gas trimmer does not work when idling EVDIRAL.RU

Build your own home!

When purchasing a lawn mower, you need to be prepared for the fact that, as in all other similar tools, breakdowns may also appear in it that will require repair.

But you should not immediately run to the service center and pay big money to the masters who convince you of the presence of a severe malfunction in the device.

When heated

The lawn mower often stops when it heats up. At the same time, it starts, works "jerky" and gradually stops. This process occurs when the gasoline in the carburetor boils or the damper is installed in a rotary rather than disc type. In the latter case, the part is changed.

It happens that the trimmer heats up if the ignition circuit wire or coil is damaged. In order for the device to start working normally, replace parts.

When you hit the gas

If the lawn mower stops when the throttle is pressed, the reasons may be as follows:.

    The most common variant is carburetor adjustment failure, which occurs when the drive is under heavy load, after prolonged inactivity of the mechanism, or when it is used in difficult conditions.

If the problem is with the carburettor assembly, the lawn mower vibrates to recognize it. When the hose bursts or the cable is stretched, these components are replaced.

Trimmer Stalls When Shutter Is Closed

At high revs

When the scythe stalls at high speeds, this is due to the following problems:

  • Clogged or sticking valve located on the gas tank cap;
  • The carburetor is out of alignment due to vibrations arising from the operation of the mechanism
  • Problems with the circulation of the fuel mixture;
  • Leakage of atmospheric air;
  • The fuel intake hose is cracked or loose.

Adjust the carburetor referring to the trimmer operating instructions. For adjustment, it is often sufficient to loosen the tightening of its housing. If there are problematic points with the circulation of the fuel mixture, then it can gradually enter the carburetor. After its development, the engine stalls at high speeds.

Why the lawn mower stalls | lawn mower | trimmer when pressing the gas, at idle, on hot

Why the lawn mower stalls when you press the gas: reasons and solutions. The lawn mower stalls (trimmer):. at idle.

  • Failure of the idle sensor;
  • Clogged throttle;
  • Throttle position sensor malfunction;
  • Dirty injector or carburetor

The grounds for a breakdown can be completely different, therefore, when eliminating them, you will have to operate with all sorts of actions and techniques. If you have a considerable driving experience behind you, and you know the features of a car like the back of your hand, regardless of the model, then eliminating this kind of problem will not give you any problems. And all because such breakdowns are not difficult or serious. It follows that you can get the car working without any help. Well, if the level of awareness or lack of free time does not give you the opportunity to eliminate all defects on your own, it is better to seek help from knowledgeable people who can save you from unpleasant moments in the shortest possible time.

Trimmer BLUNTS carburetor adjustment.

Even more information about repair and selection of tools on our website www.Looktool.Ru visit we are glad to everyone.

# spoiler # end_spoiler